Filling The Water Tank - Be Cool BC2AC2001TUF Manual De Instrucciones

FILLING THE WATER TANK

Furthermore, please note the following:
1. Push the blowout latch located above the water tank upwards, so that the water tank
can be pulled out.
2. Fill the water tank with clean water, paying attention to the fill level on the front of the
water tank:
a. MIN mark  The water tank must be filled to above the MIN mark so that
the pump can function properly
b. MAX mark  The water tank must not be filled over the MAX mark, otherwise
water could enter the inside of the appliance and thus damage electronic
parts.
3. Make sure the water tank is not damp or wet on the outside, and if so, wipe it dry.
4. Then carefully push the tank back into the air cooler and turn the safety latch back.
If you want to remove the water tank completely from the air cooler, turn
the mounting tabs located above the pump outwards to release it from the
COOL PACKS
You will receive two cool packs that can be put into the water tank for a further cooling effect.
When using the cool packs, please note the following:
1. Before use, place the cool packs in a freezer for at least 3-4 hours.
2. When inserting the cool packs into the tank, make sure that the MAX mark is not
exceeded.
When doing so, please make sure that the MAX mark is not exceeded.
NOTE
safety holder.
NOTE
Ice cubes can also be filled into the water tank.
Seite 21 von 145