DJI TAKYON Z415-M Guia De Inicio Rapido página 5

3. Be sure to use the product in strict accordance with the specifications
(voltage, current, temperature, etc.) listed in this document. Failure to
do so may result in permanent damage to the product.
4. The input throttle signal mode (regular or OneShot125) cannot be
changed while the product is in use. Set the input throttle signal mode
on your flight controller. Restart the electronic speed controller to
apply the new mode.
5. Ensure that there are no open circuits or short circuits when soldering
the power cables.
6. Before takeoff, ensure that the propellers and motors are installed correctly.
7. Ensure that all parts of the aircraft are in good condition. DO NOT fly
with worn or damaged parts.
8. Ensure that all parts are firmly in place and all screws are tight before
each flight.
Legend
Important
Introduction
The Takyon Z415-M / Z425-M Electronic Speed Controller (ESC) is
designed for racing drones. It uses a 32-bit motor driver integrated
circuit developed by DJI with a maximum main frequency of 100 MHz,
and its maximum output PWM frequency can reach 48 kHz. When using
the Takyon Z415-M / Z425-M ESC, the ripple voltage of the power supply
is 40% lower than when using an ESC of the same volume to effectively
avoid abnormal power supply to other devices. The Takyon Z425-M ESC
also uses a high-precision crystal oscillator to achieve more precise and
responsive control, and to skip throttle range calibration.
Reference
3