Fanimation NAVY LP7678LBN Manual Del Usuario página 13

How to Assemble Your Light Kit (Continued)
3. Remove one of the three screws in the light
shade assembly. Retain the screw for later and
slightly loosen the remaining two screws. (Figure 3)
4. Securely attach 9-pin connector from motor assembly
to wiring harness socket within switch housing assembly.
(Figure 4)
WARNING
The color label on these two connectors must
correspond to each other.
5. Assemble the switch housing assembly to the light
shade assembly using the two key slots in the switch
housing assembly. Replace the third screw and secure
all three screws. (Figure 5)
6. Install LED light bulb into socket by threading in a
clockwise direction. (Figure 6)
NOTE: When relamping is required, USE ONLY
MAX 6W, TYPE ST48 DIMMABLE LISTED LED
(LIGHT) BULB.
CAUTION
RISK OF FIRE. USE ONLY LED LAMPS IN THIS
LIGHT KIT. INCANDESCENT AND HALOGEN LAMPS
MAY CAUSE SEVERE THERMAL DAMAGE.
Switch Housing
Assembly
Switch Housing
Assembly
Switch Housing
Assembly
13
Light Shade
Assembly
Figure 3
Motor
Assembly
Figure 4
Light Shade
Assembly
Figure 5
LED Bulb
Figure 6