Adjust The Harness; Remove The Harness; Operation; Start The Machine - GreenWorks GD60BPB Manual Del Operario

Ocultar thumbs Ver también para GD60BPB:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
3.7

ADJUST THE HARNESS

Figure 5 - 9.
1. Fit the backpack on your back.
2. Pull the ends of the straps down to tighten the
harness.
3. Connect the horizontal chest strap.
4. Pull the end of the chest strap to tighten.
5. Lift the tabs of the adjusters to loosen the straps.
6. Lock the quick-release fastener by pushing it
together.
7. Squeeze the hooks to open the quick-release
fastener.
NOTE
Install the back pad against your back tightly and
safely.
3.8

REMOVE THE HARNESS

1. Open the quick-release fasteners on the chest strap.
2. Loosen the harness straps by lifting the sliding
adjusters and then take off the machine.
WARNING
In the event of imminent danger, quickly remove the
machine. Release the chest strap before you put the
machine on the ground.
4

OPERATION

WARNING
Make sure the blower tube is in position before
operation.
4.1

START THE MACHINE

Figure 10.
1. Pull the trigger to start the machine.
2. Pull the trigger fully to increase the speed.
3. Release the trigger to decrease the speed.
4.2

STOP THE MACHINE

Figure 10.
1. Release the trigger to stop the machine.
NOTE
Wait until the engine stops after you stop the machine.
4.3

CRUISE CONTROL LEVER

Figure 10.
English
1. Pull the cruise control lever clockwise to increase
the speed. This will lock the speed at the desired
setting.
2. Push the cruise control lever counter clockwise to
decrease the speed.
If you decrease the speed all the way, the unit will stop
and it is necessary to do the first step again.
4.4

TURBO BUTTON

Figure 10.
1. Push the turbo button, the machine is at the highest
speed.
2. Release the turbo button, the machine is at the
normal speed.
4.5

OPERATE THE MACHINE

Figure 11.
1. Hold the machine tightly with one hand.
2. Blow from side to side with the nozzle above the
ground.
3. Move forward slowly.
Keep the unwanted materials in front of you
Move heavier materials at a high speed while lighter
materials at a low speed.
4.6

OPERATION TIPS

Blow around the outer edge of the unwanted
materials to prevent the unwanted materials from
scattering.
Use rakes and brooms to clear the unwanted
material before you blow.
Make the surfaces wet before you clear the
unwanted material in dusty conditions.
Look out for children, pets, open windows, and
cleaned cars during operation.
Clean the machine.
Discard the unwanted material when you complete
work.
5
NOTE
NOTE
NOTE
EN
Tabla de contenido
loading

Este manual también es adecuado para:

2402307

Tabla de contenido