Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
1
Mounting the Wall-Mounting Bracket
Parts needed for this procedure:
Note: The bracket should be mounted indoors and out of the reach
of children.
1.
Place the bracket against the wall and mark the 2 hole locations.
2.
Drill the pilot holes.
A. If mounting the bracket on wall board, plaster, or cement,
drill 2 holes for the wall anchors (not supplied) at the marked
locations.
B. If mounting the bracket on wood, drill 2 holes slightly smaller
than the diameter of the screw threads at the marked locations.
3.
Install the screws (Figure 1).
A. If mounting the bracket on wall board, plaster, or cement,
insert the 2 wall anchors (not supplied) into the holes then
thread the screws into the wall anchors.
B. If installing the bracket on wood, drive the 2 screws into the
wall.
Description
Screw
Wall-mounting bracket
Auxiliary handle
Latch
Brace
Guard
Phillips head screw
Wire edge guard
No parts required
Qty.
2
Mount the wall-mounting bracket.
1
1
1
Install the auxiliary handle.
1
1
Mount the guard to the base of the trimmer.
1
1
Install the edge guard
Adjust the trimmer height and base
–
orientation
G018599
3
Use
1
Figure 1
Tabla de contenido
