Set The Clock - Mx Onda MX-CDP2692 Manual De Usuario E Instalacion

USING THE TOUCH CONTROLS
The controls are responsive to touch, so there is no
need to apply any pressure.
Use the entire part of the fingertip, not the tip.
Make sure controls are always clean, dry. Even a thin
layer of water can make the controls difficult to operate.

SET THE CLOCK

1. The range hood must be off.
2. Touch and hold your finger (about three seconds) on the 7 (
all indicators light and a beep sounds.
3. Touch and hold your finger on button 2 (
starts to flash.
4. Repeatedly touch the 3 (
5. Momentarily touch button 2 (
to flash.
6. Repeatedly touch the 3 (
7. After setting the hour and minute, allow 5 seconds to elapse without
touching any button or touch button 2 (
Notes:
In the event of a power failure or when the hood is disconnected from the
mains power, the current time will be erased immediately. Once the power
is restored, the display will show 12:00 so you will need to set the clock
again.
The clock shows the minutes in jumps of 5 minutes, this is due to the
design of the screen and is not a malfunction.
USE OF THE RANGE HOOD
We recommend that a few minutes before starting to cook, turn on the range
hood in order to create a constant air flow, the air flow will prevent smoke and
odors from being distributed throughout the different rooms.
) or 4 ( ) button and set the current time.
) and the minute hand indication will begin
) or 4 ( ) button and set the minute.
) to memorize the time.
7
) until the hour hand indication
) button until