Control Panel; Setting The Clock - Mx Onda MX-CDP2686 Manual De Usuario E Instalacion

CONTROL PANEL

4 2
1. Range hood on / off button and indicator.
2. Extraction speed selector button.
3. Light on / off button.

4. Setting the clock.

5. Digital indicator of the selected extraction speed.
6. Clock and sleep timer indicator.
USING THE TOUCH CONTROLS
The controls are responsive to touch, so there is no
need to apply any pressure.
Use the entire part of the fingertip, not the tip.
Make sure controls are always clean, dry. Even a thin
layer of water can make the controls difficult to operate.
SETTING THE CLOCK
The clock in this unit is designed to indicate the time in "24 hour" format. To set
the time, follow the following process:
1. The range hood must be off.
2. Touch the 4 (
3. Repeatedly touch the 3 (
4. Touch the 4 (
5. Repeatedly touch the 3 (
6. After setting the hour and minutes, allow 5 seconds to elapse without
touching any button or touch button 4 (
Note:
In the event of a power failure or when the hood is disconnected from the
mains power, the current time will be erased immediately. Once the power is
restored, the display will show the digits " 12:00 " so you will have to set the
clock again.
) button and the digits for the hour will begin to flash.
) button and set the current time.
) button and the minute digits will flash.
) button and set the minute.
5
) to memorize the time.
6
6 3 1