Main Components - Probuilder 69371 Manual De Instrucciones

Connection
a. Compressed air tool
b. Connector
c. Snap coupling
d. Compressed air hose
e. Connector
f. Snap coupling
g. Lubrication unit
h. Regulator
i. Filter
j. Non-return valve
k. Compressor

Main components

3 3
6 6
1. Handle
2. Compressed air nozzle
3. Trigger
4. Magazine release
5. Nail magazine
6. Safety release
28
1 1
2 2
4 4
5 5
Use
Loading nails
Be sure that the nail gun is not connected to
the compressed air supply.
Press the magazine trigger (4) and open the
magazine(5).
Insert the required number of nails in the
magazine. The points must point downwards
and the nails should be pushed forward by
the feeder.
Close the magazine. Check that it clicks into
place and cannot be pushed to one side
without pressing the release.
Setting nail depth
Connect the nail gun to the air supply, and
be sure that the air pressure supply is correct.
Use the pressure setting button on the air
supply (h) to adjust the depth the nail is to be
driven into the item.
Check the depth is correct on a piece of scrap
wood before using on the item.
Firing the nail gun
Load the nails required and set the depth as
described above.
Grip the handle (1), place the gun on the
item so that the safety switch (6) is depressed
and press the trigger (3) to � re a nail. Release
the trigger.
Do not press the nail gun too hard.
Disconnect the nail gun from the air hose
after use.