Troubleshooting - STEINEL PROFESSIONAL HBS 200 Guia De Informacion

Setup & Commissioning
Lens Covers
Lens covers can be used to adjust
the high bay sensor's coverage as
needed. The covers are plastic and
LC4
10ft/3m
20ft/6.1m
30ft/9.1m
40ft/12.2m
30ft/ 30ft/
9.1m 9.1m
22ft 22ft
6.7m 6.7m
LC4 reduced range
lens cover for HBS 300
(347-480V)
10ft/3m
20ft/6.1m
30ft/9.1m
40ft/12.2m
snap to the front of an HBS 300
(347-480V) or HBS 200 (347-480V).
LC5
10ft/3m
20ft/6.1m
30ft/9.1m
40ft/12.2m
35ft
40ft 50ft
10.7m
12.2m 15.2m
22ft
6.7m
LC5 180° half moon
lens cover for HBS 300
(347-480V)
LC1
50ft
15.2m
53ft
16.2m
radial
LC1 aisle starter cover for
tangential
HBS 200 (347-480V)
- 10 -

Troubleshooting

Malfunction Cause
No power at the
breaker has tripped;
sensor
light switch is in OFF
position
short circuit
Lights do not
light level setting is in
switch ON
nighttime mode during
daytime operation
lamp burned out
power is OFF
detection zone not
correctly adjusted
Lights do not
abundant heat from the
switch OFF
fixture is within detection
zone and keeps lights ON
as a result of temperature
change
Lights keep
the fixture is moving from
switching ON/OFF
side to side
Lights switch ON
HVAC vent is causing air
without obvious
flow to switch lights ON
movement
Warranty
STEINEL America warrants its products
against defects in material or workman-
ship for a period of five years.
STEINEL will replace or repair the item
provided that it has not been altered or
subjected to abuse, accident, improp-
er installation or improper use. There are
no obligations or liabilities on the part of
STEINEL for consequential damages
Remedy
reset breaker, turn light
switch to ON position,
check wiring with
voltage tester
check for proper wiring
connections
adjust light level setting
replace lamp
turn power on at
circuit breaker
readjust
mount sensor below
fixture (EM1 extender
module)
stabilize the fixture
redirect air flow away
from the sensor
arising out of or in connection with the
use or performance of this product or
other indirect damages with respect to
loss of property, revenue,
or profit, or cost of
removal, installation or
reinstallation.
- 11 -