Tabla de contenido
Quick Start
Step 1: Power and Antenna Connection
① Connect an antenna to each of the antenna connectors.
② Connect the power supply to the receiver and plug into an AC power
source.
③ Connect the receiver audio output to a mixer or amplifier.
④ Press and hold the power button to turn on the receiver.
PS23
INSTRUMENT OUT
Step 3: Install Batteries into Transmitter
① Accessing the Battery Compartment
Press the side tabs on the bodypack or unscrew the
cover on the handheld as shown to access the battery
compartment.
Step 4: IR Sync to Create an Audio Channel
1. Turn on the transmitter.
2. Press the
button on the receiver. The red
sync
will blink indicating that sync mode is active.
3. Align the IR sync windows of the transmitter and
receiver at a distance of <15 cm (6 in.). When the
transmitter and receiver are aligned, the red
remains on and the sync will automatically occur.
Step 5: Sound Check and Gain Adjustment
1. Test the transmitter at performance levels while monitoring the
LED. The
meter should display at least 3 bars and the
audio
audio
be green. Reduce the gain if there is audible distortion of the audio.
2. Increase or decrease the gain if necessary by pressing the arrow buttons on the
receiver front panel.
12
INSTRUMENT OUT
② Installing Batteries
- AA Batteries: Place batteries (note polarity markings) and AA Adaptor as shown
- Shure SB900 Battery: Place battery as shown (note polarity markings), remove AA Adaptor from
bodypack transmitter, stow AA Adaptor in door for handheld transmitter
Note: If using AA batteries, select a battery type from the transmitter menu to ensure accurate battery
metering.
LED
ir
LED
ir
< 15 cm (6 in.)
audio
meter and the
audio
Step 2: Scanning for the Best Available Channel
1. Press the
button on the receiver to access the scan function.
menu
scan
group channel
2. Press the
button to start a frequency scan. The scan icon will flash while
enter
in scan mode. When the scan is complete, the selected group and channel
appear on the display.
TV
group channel
rf
audio
gain
AA Batteries
on
AA Adapter
4.
sync good
blue
rf
range of the receiver.
Note: If the IR sync fails, repeat the IR sync procedure, carefully
maintaining alignment between the IR windows of the transmitter and
receiver.
TV
LED should
hr
mn
group channel
menu
audio
rf
ir
enter
sync
MHz
menu
audio
rf
ir
dB
enter
sync
Shure SB900 Battery
AA Adapter
appears on the display when IR sync is complete. The
LED will illuminate indicating that the transmitter is within
menu
audio
rf
ir
sync
enter
MHz
dB
rf
audio
gain
on
Tabla de contenido
