Bulb Replacement - Ecom Lite-Ex PL 10e H Instrucciones De Uso

The lamp head can then be screwed back onto the lamp.

8.5 Bulb replacement

The Lite-Ex PL 10e H is equipped with a long-life LED
®
bulb. Under normal conditions it is not necessary to change
the LED. If, however, the lamp becomes defective or its
brightness has diminished, it should be sent to ecom inst-
ruments for inspection or repair. The LED housing should
not be opened! Conducting repairs to the LED housing or
bulb yourself poses a risk to the safety of the lamp and is
not permitted.
8.6 Replacing the protective disc
The LED housing is protected by the surrounding housing
head and an additional protective disc, which is located over
the opening where the beam is emitted. The disc is made
of high-quality material. If, however, it should break, it can be
replaced. To do this, grasp the body of the Lite-Ex PL 10e
®
H and the ring switch and then carefully unscrew the lamp
head by turning it anti-clockwise. To unscrew the lamp head
from the LED housing use an Allen key (A/F 4) to secure
the LED housing in place (see Fig. 3) and unscrew the
lamp head. The protective disc can now be replaced (only
use original protective discs from ecom). The LED housing
should then be cleaned thoroughly and the sealing ring
checked for signs of damage. If the sealing ring exhibits any
damage, it should also be replaced (the sealing ring is set in
a groove underneath the protective disc / only use original
sealing rings from ecom). When replacing the lamp head
on the LED housing make sure the seal and disc are seated
properly. After assembly no part of the seal should be visible
through the opening where the beam is emitted. If the inner
lamp head or lens has been damaged, the lamp should be
sent to the manufacturer for repair.
10