Tabla de contenido
Idiomas disponibles
Idiomas disponibles
•
Always unplug the unit before servicing it in any way.
•
The water temperature of the water remaining in the unit after use may be high.
•
Do not submerse the unit in water, or allow water to enter anywhere on the unit
except the designated water tank.
INSIDE THE BODY OF THE UNIT
Pour excess water out of the unit, but do not allow it to enter the blast port. Wash out the unit
with fresh water, using the cleaning brush and a soft cloth as needed.
OUTER SURFACE OF THE UNIT
Wipe the surface of the unit with a soft, damp cloth if needed.
WATER TANK
If water spots remain in the water tank, wipe the inside with a soft cloth.
Do not use soap or detergents.
AIR FILTER
Gently wipe away debris from the filter with a soft cloth.
ULTRASONIC DISK
Remove spray spout (Fig. 1) and use the enclosed cleaning brush to regularly remove build up
and deposits from this area (Fig. 2). White vinegar will help to prevent this build up.
Fig. 2
Fig. 1
•
Fully dry the inside and outside of the unit before storing it.
•
DO NOT leave water in the unit.
•
Store in a cool, dry place.
E-8
PROBLEM
Water vapor & humidity are
not produced.
Air blows but water vapor is
not produced.
Humidity level is low.
Warm humidity is not produced.
The humidity has a bad smell.
White dust is forming on
nearby furniture.
My current humidity will not
go below 25%.
SOLUTION
Power Plug: Unplug and then try again.
Power Failure: When the power is returned, try
again.
Tank Installation: Make sure the water tank is
correctly attached.
Excessive Water: Remove a certain amount of
water from the tank.
The desired humidity is lower than the current
temperature: Increase the desired humidity.
Detergent residue in the tank: Wash the tank out
and try again.
The surface of the ultrasonic metal disk may be
dirty: Wipe it off with a dry, soft cloth.
The water in the unit is too cold: Replace with cool,
but not cold water.
Damage on the ultrasonic metal disk:
Contact customer service at 1.866.603.5900.
It may take 10-15 minutes before warm
humidity is created. The steam may not feel
warm to the touch.
Poor maintenance or dirty water: Clean the product
thoroughly, and fill it with fresh water.
Hard water will deposit a certain amount of dust.
Dust in the air settles because of the added
humidity in the room.
*Use distilled water if this becomes a nuisance.
The unit will not display a humidity setting below
25%. This means the current humidity in your room
is at OR below 25%.
E-9
Tabla de contenido
