The Controls - Creda HB37679 Libro De Instrucciones

The Controls

Setting the timer
Selecting the
required Heat
Setting
Starting the
Dryer
Empty Water
Light
Mains light
8
Control panel
Start switch
The drying time for both heat settings is controlled by the timer. All
you have to do is turn the Timer Control clockwise until the required
time appears in line with the indicator.
Do not rotate the knob beyond 120 (maximum drying time) or past
the zero stop. If you have selected more time than you require turn
the knob anti-clockwise to select the correct time required.
The "Guide to Drying Times" section will tell you how much time
you'll need for various loads.
To select high heat (Cottons), the Heat Selection switch must be IN.
To select Low heat (Acrylics and Synthetics) the Heat Selection
switch must be OUT.
A green mark on the push button is visible when low heat is selected.
See section "Guide to Drying Times".
Press and release the START button to commence a drying program
(The drying time must have been selected first).
NOTE: If the door is opened during a programme the
Dryer will automatically stop.
To continue the programme after closing the door, the
START button must be pressed.
This light will glow when the water container is full.
You should not wait for this light to glow before emptying the water
container, but empty it after each load (see section "Emptying the
Water Container").
NOTE: When the light glows you must stop the dryer and empty the
water container.
If the water light glows during a drying cycle the timer will advance to
the Cool Tumble Phase without drying the load.
The light will take approximately 10 seconds to go out after replacing
the empty container.
This is lit when the dryer is plugged in and the supply switched on.
Mains light Empty water light
Heat Selection Switch