Viega Tempoplex 6961 Manual Del Usuario página 10

GB
Instructions for Use for Tempoplex Shower Drain
Use in keeping with intended purpose
The Tempoplex drain is suitable for installation in flat and superflat shower trays with
a 90 mm drain hole. Only the usual kinds of household waste water up to 95 °C may
be fed in. Feeding in other liquids is not allowed. No harmful substances are to be fed
in, such as cleaning agents which damage sanitary equipment, draining elements and
pipe materials, and particularly those with a pH value ≤4. Specialist firms should carry
out installation with consideration given to the building provisions. The shower drain
conforms to EN 274.
A
Model Article No Available as
6961 575 601
6961.1 575 625
B
Components
Cove
 
C
Dimensions
D
Installation procedure
Before installation, check whether the draining rate of 0.6 l/s with a 15 mm penned-up height is sufficient.
45° drain elbow DN 40/50 is made of polypropylene (non-adhesive).
Place double seal on the

sealing surface and press
into the retaining groove.
Tighten the screws evenly.

Do not use a cordless
screwdriver.
E
Special case
If the floor of the shower

tray is thicker than 10 mm,
separate the seal.
F
Access to the drainage system (cleaning)
Make sure that the odour trap is not damaged during the cleaning process.
Remove the immersion

tube.
Insert the sealing plug flush

by hand.
518352_Tempoplex_Duschabl.indd 10
with cover with
45° draining elbow
without cover with
45° draining elbow
Immersion Clamping collar

tube with screw
Position drain piece with seal

under the shower tray. Guide
the upper section of the double
seal through the drain hole.
Insert immersion tube into

the water trap.
Cut above the lower sealing bead.

Remove the sealing plug by

turning gently with pliers.
Note the plug position.

Model Article No Available as
6961.175 575 632
6961.875 575 625
Seal






10
without cover
with cover
Water trap

Screw in the fixing screws
by hand.
Press cover onto the three
attachment points.
Place the lower part on the
drain housing and the upper
part in the drain hole.
Clean the drain pipe with
an appropriate cleaning
process.
Position the immersion
tube and mount the cover
(see fig. D 6).
03.11.2011 07:19:25