Connect Hose And Water Supply To Pump; Important; Checklist Before Starting Engine - Craftsman 580.752710 Instrucciones De Uso

2. Push to "snap" cartridge into place.
3. Remove tab to expose membrane.
IMPORTANT: DO NOT remove the silver foil seal on
the opposite side.
4. Reinstall fuel cap on fuel tank.
5. Periodically check the cartridge to ensure there is
still fuel stabilizer inside. If it is empty, remove
cartridge and replace.

Connect Hose and Water Supply to Pump

IMPORTANT: To avoid pump damage, you must
assemble the nozzle extension to the spray gun and
attach all hoses before you start the engine.
1. Uncoil high pressure hose and attach one end of
hose to base of spray gun. Tighten by hand.
2. Remove and discard shipping caps from pump
inlet and outlet.
3. Attach other end of high pressure hose to high
pressure outlet on pump. Tighten by hand.
4. Before connecting garden hose to water inlet,
5. Run water through garden hose for 30 seconds to
IMPORTANT: DO NOT siphon standing water for the
water supply. Use ONLY cold water (less than 100°F).
6. Connect garden hose (not to exceed 50 feet in
There MUST be at least ten feet of unrestricted garden
hose between the pressure washer inlet and any flow
shut off device, such as a 'Y' shut-off connector or other
convenience-type water shut-off valve.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
7. Turn ON water and squeeze trigger on spray gun
• Always wear eye protection when using this equipment
or in vicinity of where equipment is in use.
• Before starting the pressure washer, be sure you are
wearing adequate eye protection.
CHECKLIST BEFORE STARTING
ENGINE
Review the unit to ensure you have performed all of
the following:
1. Make sure handle is in place and secure.
2. Check that oil has been added to proper level in
3. Add proper fuel to fuel tank.
4. Check for proper hose connections (high pressure
5. Provide proper water supply (not to exceed
Inspect inlet
screen. DO NOT
6. Be sure to read "Safety Rules" and "Operation"
use if damaged;
clean if dirty.
9
inspect inlet screen. Clean screen if it contains
debris or have it replaced if damaged. DO NOT
run pressure washer if inlet screen is damaged.
flush it of debris. Turn off water.
length) to water inlet. Tighten by hand.
CAUTION
to purge pump system of air and impurities.
WARNING
High pressure spray can cause paint chips
or other particles to become airborne.
engine crankcase.
and water supply) and that there are no kinks,
cuts, or damage to the high pressure hose.
100°F).
sections before using the cleaning system.