Tabla de contenido
Idiomas disponibles
Idiomas disponibles
•
For maximum rinsing (higher pressure and
lower flow), for stubborn or hard to reach
surface such as second story surfaces, paint
removal, oil stains, rust removal or other
stubborn substances (tar, gum, grease, wax,
etc.), select red max ProjectPro™ nozzle.
•
To apply detergent, applies project specific
cleaners to help break down stubborn dirt and
grime on a variety of surfaces, select black
ProjectPro™ cleaning detergent nozzle.
4. Pull back on collar, insert selected ProjectPro™
nozzle and release collar. Tug on ProjectPro™
nozzle to make sure it is securely in place.
5. For most effective cleaning, keep ProjectPro™
nozzle from 8 to 24 inches away from cleaning
surface. If you get the nozzle too close, you may
damage the cleaning surface.
6. DO NOT get closer than 6 inches when cleaning tires.
Cleaning and Applying Chemical
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could
damage the pump.
CAUTION
You must attach all hoses before you start the engine.
• Starting the engine without all the hoses connected and
without the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
To apply detergent follow these steps:
1. Review ProjectPro™ nozzle use.
2. Prepare chemical solution as required by
manufacturer.
3. Pour chemical solution into chemical reservoir
labeled A or B.
NOTE: Each chemical reservoir holds two quarts.
4. Fill other chemical reservoir with a different
prepared solution, as desired.
5. Make sure black ProjectPro™ cleaning detergent
nozzle is installed.
NOTE: Detergent cannot be applied with the high
pressure nozzles (Yellow, Orange or Red).
6. Make sure garden hose is connected to water inlet
and water supply is turned on. Check that high
pressure hose is connected to spray gun and
pump; start engine.
7. Rotate chemical shut-off valve on desired
chemical reservoir to "On" position.
"On" Position
CAUTION
DO NOT turn on both chemical shut-off valves at the
same time.
• Only one chemical solution should be used at a time to
avoid possible bodily injury and/or property damage.
8. Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward,
using long, even, overlapping strokes.
9. Allow detergent to soak in between 3–5 minutes
before washing and rinsing. Reapply as needed to
prevent surface from drying. DO NOT allow
detergent to dry on (prevents streaking).
13
"Off" Position
Capítulos
Tabla de contenido
