Assembly - Graham Field LUMEX RJ5500 Instrucciones De Ensamblaje Y Operación

ASSEMBLY

Refer to pictures at right during
assembly.
Install the Handles
s NOTICE: Ensure brake
cables are OUTSIDE
handles.
1. Install both handles in frame
handle receptacles as shown
in fig. 2.
2. Insert hex bolt heads in hex
indents on insides of handles
while inserting hex bolts
through handles as shown in
fig. 3.
3. Install female knobs on ends
of hex bolts on outside of
handles as shown in fig. 4.
4. Tighten knobs.
5. Secure both brake cables onto frame with brake cable clips as shown in fig. 6.
WARNING: Ensure both handles are adjusted to the same height and handle knobs are
tight before proceeding.
Install the Legs
Info: As shown in fig. 5, each frame leg tube has a number corresponding to one of the
four legs. Match each number at upper end of leg to each number on frame tube.
1. Lay the Rollator on its side to install the legs.
2. Install both front legs: Match leg number to frame tube number and insert leg into tube as
shown in fig. 5. Secure with E-clip and male knob as shown in fig. 6.
RJ5500-INS-LAB-RevA18
fig. 5
fig. 2
fig. 6
fig. 3
fig. 4
3