Landxcape LX790 Guia De Instalacion página 9

before the
TM
When connecting the power cord of the charging base to the adapter, align
the notch on the power cord (b) with the groove on the adapter (a).
Connect the adapter to the electrical outlet. The LED on the charging base
will turn on in green color. Manually dock Landxcape TM into the charging
base while Landxcape TM is powered off. The green light on the charging
base will be flashing and Landxcape TM will begin to charge.
If the power cord is in Landxcape TM 's working area, you may bury it if
desired.
wall.
3. Peg the boundary wire
Before pegging the boundary wire, it is recommended to use a normal
lawn mower or a grass trimmer to cut the grass along the boundary. Then
the wire should be laid as close as possible to the ground to prevent your
RED BLACK
Landxcape TM accidentally cutting the wire. The boundary wire is powered
with a very low voltage totally safe to humans and pets.
Pull out a length of boundary wire around 80cm and fasten it to the ground
near the charging base. Later, this end of the boundary wire (IN-wire) will
be connected to the BLACK terminal after pegging your boundry wire.
NOTE: The extended boundary wire should not exceed 400m or it may
cause signal problem.
EN 9