FIM M Serie: C Serie Manual De Uso Y Mantenimiento página 29

The grease which accumulates on dirty filters is easily inflammable and can cause fires, if they
are not removed by periodic washes.
The manufacturer declines any responsibility for fires caused by poor maintenance of the grease
filters.
Do not install or remove the grease filters with the engine running.
Never activate suction without fitted grease filters.
The Company declines all liability if the above warnings are dropped.
CARBON FILTERS
The carbon filters are used to retain the odours of the kitchen fumes. It is not necessary to use
carbon filters.
The use of carbon filters is necessary if you use the hood as filtering.
Please follow and read the instructions given with the carbon filters as far as mounting and
regenerated/substitution are concerned.
Carbon filters that cannot be regenerated:
we advise to replace the carbon filters after circa 300-400 hours of use of the cooking top.
The carbon filters that cannot be regenerated cannot be either washed nor regenerated but
need to be replaced when expired.
REPLACEMENT OF LAMPS (as expected)
Always replace the lamps with lamps which have the same electrical characteristics (see
TECHNICAL DATA). Before replacing the lamps, make sure that they are cold and that power has
been completely turned off.
Please follow the sequenze as shown in L series pictures.
Reconnect to electricity.
If te lights are not working, check that the lamps are correctly fit.
CLEANING
To preserve the hood in good condition, clean this periodically following the advice given as
follows.
Make sure that power has been completely turned off.
The detergent solution recommended is a combination of WATER and NEUTRAL LIQUID SOAP.
It is of vital importance that the liquid soap should not contain any grains which could scratch
the surface.
The solution should be applied first onto a soft cloth which is then rubbed over the shell. It is
important to follow the pattern of the satin finish with the cloth.
It is absolutely forbidden to pour liquids directly onto the hood.
The cloth used should not have any buttons, zips, fasteners or anything else which could scratch
the surface.
The use harsh abrasive or granular products, petrol, spirits or similar products which could
damage the surface of the materiall, is severely forbidden.
The manufacturer will not be responsible for any damages either functional or to the appearance
of the hood, caused by cleaning operations carried out using unsuitable products or unsuitable
methods.
During cleaning, do not overuse the keys in order to avoid accidental ignition.
29