FIM M Serie: C Serie Manual De Uso Y Mantenimiento página 25

Press at the same time the push buttons
■
interval function will be activated.
When you are in the setting phase, if the interval function shown is not confirmed within some
seconds, then you get out of the setting mode for the interval function.
Deactivate: you can deactivate pressing any push button but not the light push button.
AUTOMATIC CONTROL OF GREASE FILTERS AND CARBON FILTERS
The electronic controls with display and rectangular push buttons allow automatic control of the
grease filter and of the carbon filter (only when the hood is used in filtering version) so that the
user does not have to remember when maintanance was last carried out.
When the grease filters must be cleaned, there is
is issued.
When the carbon filters must be replaced, there is the
acoustic signal is issued.
TO PUT THE GREASE AND/OR CARBON FILTER CONTROL BACK TO ZERO
After filter maintanance has been carried out you have to:
Stop the motor (stop position);
■
Press twice in succession the
■
symbol is appearing in the display and a "beep" is issued.
SETTING SUCTION/FILTERING FUNCTION
The hood is delivered standard as a suction hood (saturation indicator
If the hood uses a plasma filter, do not set it in filtering mode.
If you wish to use the hood as filtering (saturation indicator
following:
Press at the same time for ca 5 seconds the push buttons
■
you will have the
To reset the hood just for suction use, repeat the above, in the display you will have the
symbol appearing.
Additional Functions: SECONDARY LIGHT
If you keep on pressing the light Push button
disactivate the secondary lights.
Additional Functions: MICROSWITCH for hoods with movable front parts or drawers
This switch is making the switching on/off operation easier. If you open or close a door or if you
pull out a drawer according to the kind of cooker hood (which is always an advised operation if
the fires are on) the motor is starting at the second speed; all functions of the controls are
allowed.
SOFT TOUCH CONTROL WITH DISPLAY AND RECTANGULAR PUSH BUTTONS
It switches the lights on and off.
Where foreseen, the prolonged pressure varies with the intensity of the light.
It switches the motor off.
push button, to confirm that reset has been made the
symbol followed by an acoustic signal.
and to confirm the speeds at which the
flashing in the display and an acoustic signal
letter flashing in the display and an
for more than 2 seconds you activate/or
25
).
and ) please do the
and , in the display