Speedaire 1WD5 Serie Instrucciones De Operación Y Manual De Partes página 8

Speedaire
Operating Instructions & Parts Manual
Speedaire
Two-Stage Air Compressors
Guide To Maintenance
For Service call 1-888-303-1344.
All request should include model
number and serial number. To
E
obtain reliable and satisfactory
N
service, this unit requires a
G
consistent preventive
L
maintenance schedule.
I
Maintenance schedule forms
are included to aid in keeping
S
the proper records.
H
performing any
maintenance function,
switch main disconnect
switch to "off" position to
assure no power is
entering unit. "Lock out"
or "tag out" all sources of
power. Be sure all air
pressure in unit is relieved.
Failure to do this may
result in injury or
equipment damage.
Daily Maintenance
1. Check oil level of compressor.
Speedaire
Add
as required. See "Compressor Oil
Specifications" Section.
NOTE: Do not mix oil
type, weight, or brands
For Service and Warranty, Call: 1-888-303-1344
10 & 15 HP
®
2. Drain moisture from tank
by opening tank drain
valve located in bottom
of tank. Do not open
drain valve if tank
pressure exceeds 25 PSIG.
3. Turn off compressor at
the end of each day's
operation. Turn off power
supply at wall switch.
Weekly Maintenance
1. Clean dust and foreign
matter from cylinder
Before
head, motor, fan blade,
air lines, intercooler and
tank.
2. Remove and clean intake air
filters.
exceed 15 PSIG nozzle
pressure when cleaning
element parts with
compressed air. Do not
direct compressed air
against human skin.
Serious injury could result.
Never wash elements in
recip lubricant fuel oil, gasoline or
flammable solvent.
3. Check V-belts for tightness.
The V-belts must be tight
enough to transmit the
necessary power to the
compressor. Adjust the
V-belts as follows:
.
1WD50, 1WD52, 1WD67, 1WD68, 1WD70 thru 1WD76, 1WD78
Do not
8
a. Remove bolts and
guard to access
compressor drive.
b. Loosen mounting
hardware which secures
motor to base. Slide
motor within slots of
base plate to desired
position.
c. Apply pressure with
finger to one belt at
midpoint span. Tension
is correct if top of belt
aligns with bottom of
adjacent belt. Make
further adjustments if
necessary.
d. Check the alignments
of pulleys. Adjust if
necessary.
e. Tighten mounting
hardware to secure
motor on base.
f. Re-install guard and
secure with bolts.
Never operate unit
without belt guard in place.
Removal will expose rotating parts
which can cause injury or
equipment damage.