Axle; U" Bolt; Snap Pin; Washers - Anest Iwata DDP 70 B Manual De Instrucciones De Uso Y Mantenimiento

DPS-70 C - DPS-70 CN DIAPHRAGM PUMPS
C
1.
Assemble the following parts below in numerical order, and fix them to the stand.
4. Washer

5. Snap Pin*

Unscrew the fitting bolt (M6) from pump lower adaptor, assemble the handle to lower adaptor and stand by using the
2.
same hex. bolt (M6) and fix the other side of the handle by using and hex. bolt (M8) and the nut (M8).
Hex. Bolt (M8)

Hex. Nut (M8)

D
1.
Remove the dust proof caps (B,E,F,H,I on page 15)
2.
Detach the pump assembly from bracket by removing Hex. Bolts (M6).
3. Flip the bracket and assemble the pump to the right position on bracket by using Hex. Bolts (M6).
4.
Connect the drain hose to the two-way valve for paint recirculation. (as COMMON 1)
5.
Connect the suction hose to the paint inlet joint.
Hex. Bolt (M6)
E
GRAVITY HOPPER TYPE (6 lt.)
Assemble the hopper set by means
the "U" suction tube, to the paint
1.
inlet joint of the pump mounted
on cart.
Connect the drain hose from two-
2.
way valve for paint recirculation to
hopper lid set directly.
3. Tire
2. Washer

Axle

1. Snap Pin*

Handle

Hex. Bolt (M6)
WALL MOUNTING TYPE
Wall bracket
CART TYPE
Hex. Nut

"U" Bolt

2
1
*Put the end of the
pin into axle hole,
and push it inside
all the way by
using hammer.
As is when is fitted.
Band 3 spots wherever
you want
Suction hose
Suction hose
Drain hose
EN
13