Before Starting Engine - Powerplay HOTROD HR230HR24PPLSEZ Instrucciones De Ensamblaje, Cuidado Y Uso

Before Starting Engine

Checking/Adding Engine Oil
With power washer on a smooth and level surface, remove
oil fill cap/dipstick. Check the oil level is between "L" and
"H" on the dipstick.
If needed, use an oil funnel to slowly pour oil into oil
fill opening. See Maintenance section for oil type
recommendation. Replace oil fill cap/dipstick and fully
tighten. DO NOT OVERFILL.
NOTE: Any attempt to start the engine without proper
service and/or maintenance that uses the recommend oil
may result in engine failure.
Adding Fuel
Remove fill cap and slowly add regular unleaded fuel
to fuel tank without overfilling. Fill to lower side of filter
screen. Replace the fill cap to cover the gasoline, and let
any spills evaporate before starting the engine.
Fuel must meet these requirements:
• Clean, fresh, unleaded gasoline.
• A minimum of 87 octane/87 AKI (91 RON).
• Gasoline with up to 10% ethanol (gasohol) is
acceptable.
NOTE: Avoid physical damage to the pressure washer.
Failure to follow recommendations in the Operator's
Manual will void warranty on this machine.
• DO NOT use unapproved gasoline such as E85.
• DO NOT mix oil with gasoline.
• DO NOT modify the engine to run on alternative fuel.
DANGER
Explosion and Fire. Fuel and vapors are extremely
flammable and explosive. Add fuel in a well ventilated
area. Keep fire and spark away. Failure to do so will
result in death or serious injury.
11