Diffuser Cap Assembly; Operation - Dirt Hound DH05000 El Manual Del Propietario

SP6669 5 Gallon Dirt Hound.qxd
Female Port
on Vac
Adaptor
To reduce the risk of fire or explosion, do not operate this vac in areas with
flammable gases, vapors or explosive dust in the air. Flammable gases or
vapors include but are not limited to; lighter fluid, solvent type cleaners, oil-
base paints, gasoline, alcohol or aerosol sprays. Explosive dusts include but
are not limited to; coal, magnesium, aluminum, grain or gun powder. Do not
vacuum explosive dust, flammable or combustible liquids or hot ashes. Do not
use this vac as a sprayer. To reduce the risk of health hazards from vapors or
dusts, do not vacuum toxic materials.
WARNING: The operation of any
!
utility vac can result in foreign
objects being blown into the eyes,
which can result in severe eye
damage. Always
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
starting operation. Safety eyewear
are available at many local retail
stores.
CAUTION: To reduce risk of
!
hearing damage, wear ear protectors
when using the vac for extended
hours or when using it in a noisy
area.
To reduce the risk of electric shock, this
appliance has a polarized plug (one blade
is wider than the other). This plug will fit in
a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the
6/29/07 2:08 PM

Diffuser Cap Assembly

Connect the lanyard to the attachment tab
on the vac motor assembly to keep the
diffuser attached to vac when using the
blower port. The diffuser cap can be used
in the exhaust port of the Wet/Dry Vac.
Installing the diffuser cap will allow you to
diffuse the exhaust air in any direction and
reduce the intensity of the exhaust force.
Male End
of Hose

Operation

WARNING
!
plug. If it still does not fit, contact a
qualified electrician to install the proper
outlet. Do not change the plug in any way.
After you plug the power cord into the
wear safety outlet, turn the unit on by pushing the
switch from position "O" to position "l". The
symbols used on the switch actuator are
international "On & Off" symbols. "O" is
the symbol for "OFF" and "l" is the symbol
for "ON".
WARNING: To reduce the risk of
!
fire, do not run vac unattended.
11
Page 11
Attachment
Tab
Lanyard
Diffuser
= OFF = ON