Under The Cabinet Installation; Preparation Before Installation; Hood Installation - KOBE CH7630SQB Intrucciones De Instalación

Preparation before Installation

NOTE: TO AVOID DAMAGE TO YOUR HOOD,
PREVENT DEBRIS FROM ENTERING THE
VENT OPENING.

Decide the location of the venting pipe
from the hood to the outside. Refer to
Figure 1.

A straight, short vent run will allow the
hood to perform more efficiently.

Try to avoid as many transitions,
elbows, and long run as possible. This
may reduce the performance of the
hood.

Temporarily wire the hood to test for
proper operation before installing.

Important: Peel protective film off the
hood, if any.

Use duct tape to seal joints between
pipe sections.

For installing under the cabinet with
recessed bottom, attach 4-inch wide
wood filler strips (not provided) on each
side. Refer to Figure 2.

Using references in TABLE 1 and
Measurements and Diagrams on page
18, create access opening for electrical
wires and hood exhaust under the
cabinet.

Hood Installation

CAUTION
:
range is necessary to install the hood, turn
off the power on an electric range at the
main electrical box. SHUT OFF THE GAS
BEFORE MOVING A GAS RANGE.
1. Puncture the knockout holes (for mounting
under the cabinet) on the hood as shown in
Figure 3.
2. If necessary, attach two rubber stands
(provided) with
(provided) to the back corners of the hood.
3. Using references
Measurements and Diagrams on page 18
center the hood beneath the cabinet and
flush with the front of the cabinet.

UNDER THE CABINET INSTALLATION

If moving the cooking
3M adhesive tapes
in TABLE 1
Figure 1
Figure 2
.
Figure 3
and
6