AERMEC Srp ELESTA DOMOTESTA 300 Manual De Uso página 23

1 2 3 4 5 6 7
Dat.
Dat.
24
2
22
20 4
A
18
6
16 C
8
14
10
B
12
Service
K
1-7 N
1
2
4
FLOOR DRYING PROGRAM SETTING
-3 +3
PC-Sercvice
3
This function is used to start the drying floor program; this
is a special program that is included in case systems with
radiating panels are installed; this program must be set by
selecting the A2 (B) parameter (the mode with which the
parameter is reached is indicated on the previous page),
this parameter activates the program if a value other than
0 is set (using the or
temperature is fixed, press
at least for 5 seconds to start the program.
The operation logic of this program is very simple:
• once activated, this program changes, gradually (in six
days), the unit delivery temperature from 20°C (default
value that cannot be modified by the user) to the maximum
value set in the A2 parameter;
• once the set temperature is reached on the A2 parame-
ter, it is maintained for three days;
• after this time, the delivery temperature starts decre-
asing until reaching the default temperature (20ºC) and
then the floor drying program is disabled; this part takes
six days;
Remember that during the activation of the program,
the program selector should be set on reduced (from
the moon symbol), also remember that the zone symbol
flashes during the drying program;
To disable the program before the cycle is completed,
set the A2 parameter to 0 and press
seconds.
keys), and once the maximum
for more than 5
23