Echo SRM-225 Instrucciones De Instalación página 2

U-
2
handle
i
nstallation
Tools Required: 8mm x 10mm Open End Wrench, T-wrench,
Torx T-27 L-Wrench
1. Close choke and remove air filter and cover.
2. Disconnect ignition stop leads (A) and (B).
3. Loosen nut (C) and remove throttle linkage from carburetor bracket
(D).
4. Remove inner throttle cable (E) from carburetor swivel (F).
5. Loosen the two (2) drive shaft clamp bolts (G) at engine drive shaft
clamp.
6. Pull drive shaft assembly from clutch case.
7. Loosen two (2) rear handle screws (H) and pull rear handle from
the drive shaft assembly.
8. Loosen four (4) screws (I) and remove front handle.
9. Insert square nut (J) in lower handle bracket (K) and place bracket
on drive shaft 400 mm (15 3/4 in.) from engine end of drive shaft.
10. Secure with lower handle bracket clamp (L) and three (3) 5 x 25
mm bolts.
C K i
ombo it nstallation
i
nstrUCtions
A
B
E F
C
D
G
I
H
J
K
L
H