Care And Cleaning - Whirlpool WPEC12MW Manual De Uso Y Cuidado

CARE AND CLEANING

Your new evaporative air cooler is designed to give you many
years of dependable service. This section tells you how to clean
and care for your Evaporative air cooler properly.
Cleaning the Air Filter
The air filter is removable for easy
cleaning. A clean air filter helps remove
dust, lint, and other particles from the air
and is important for the best operating
efficiency. Check the air filter every two
weeks to see whether it needs cleaning.
NOTE: For best performance, do not
operate the Evaporative air cooler
without the air filter in place.
Rinse the air filter under the faucet. If the filter is very dirty, wash
it in warm water with a mild detergent.
NOTE: Do not wash the air filter in the dishwasher or use any
chemical cleaners; it may damage the filter. Air dry the filter
completely before replacing to ensure maximum efficiency.
Remove the filter
Remove the filter from back of the unit by using your thumbs to
press down on the tabs directly above the filter.
Reinstalling the filter:
1. Wait until the filter is completely dry.
2. Reinstall the filter in the Evaporative air cooler.
8
Cleaning the Evaporative
Media Cartridge
The evaporative media cartridge
is located behind the air filter.
To clean, remove the air filter,
then pull out the cartridge. The
cartridge should be cleaned
regularly by soaking it in warm
water with a few drops of
mild liquid dish detergent for
several minutes then rinsing it
thoroughly. Allow the cartridge
to dry before reinstalling.
NOTE: The cooling function
will not operate without the
evaporative media cartridge
in place.
Cleaning the Evaporative Air Cooler
Cabinet
1. Turn off and unplug the evaporative air cooler.
2. Wipe the evaporative air cooler cabinet with a soft, damp
cloth.
3. Wipe dry with soft cloth.
Cleaning the Water Tank
The water tank should be cleaned every few weeks to prevent
mold and mildew growth.
1. Remove the water tank.
2. Wash the tank with a mixture of warm water and a mild
detergent.
3. Rinse well, then reinstall water tank.
Storing the Evaporative Air Cooler
If the evaporative air cooler will not be used for an extended
period of time, prepare it for storage with the following steps:
1. Turn off the evaporative air cooler and unplug it.
2. Empty the tank.
3. Remove, clean, and reinstall the filter.
Installing/Replacing the Battery in the
Remote Control (on some models)
To install a new remote control
battery:
1. Open the battery holder on the
remote control.
2. Remove the old battery (if
present) and insert a new 3V
CR2032 battery, being sure
that the + symbol on the battery
is facing up.
3. Slide the battery holder back
into the remote until it locks
into place.