Fanimation AIRE DROP LP8068LMW Manual Del Usuario página 13

How to Assemble Your Light Kit (continued)
2. Assemble the light kit to the support bracket using
the two key slots in the light kit. Replace the previously
removed screw and securely tighten all three screws.
(Figure 2)
3. Remove the three screws in the light kit and retain
the screws for later. (Figure 3)
4. Connect the 2 single pin connectors from the LED
assembly to the 2 single pin connectors from motor
assembly. (Figure 4)
5. Assemble the LED assembly to the light kit using
the removed screws from Step 3 and secure all three
screws. (Figure 5)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
6. Secure the glass to light kit
clockwise direction. Do not over-tighten. (Figure 6)
by twisting in a
13
Light Kit
Figure 2
Light Kit
Figure 3
Motor
Assembly
Figure 4
Light Kit
LED Assembly
Figure 5
Light Kit
Figure 6
LED Assembly
Glass