Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
5. INSTRUCTIONS FOR USE
a. Video door phone
If needed, remove the protective film from the screen and the camera lens
face of the visitor is displayed for approximately 90 seconds.
If you are in "photo frame" mode, the face of the visitor is displayed and the "photo frame" function
will return at the end of the time delay or at the end of your communication.
Once the visitor identified, press the key
A single push on the key
This function is only available if the screen is in video door phone mode.
.
switch on immediately (for approx. 75 sec.).
The sound level can be set on the right side of the monitor (3 setting positions).
Caution: In case of power outage, it is normal that the video door phone rings
b. Photo frame
To view pictures, to listen to music with MP3 format or to watch a DIV-X movie (3.11-5.05 version)
on your "photo frame". You should previously load them onto a SD, MMS or a MS card and insert
it into the reader on the left of the frame.
You can also use a USB key (do not use hard disk) and insert it into the USB port on the right side
of the frame.
IMPORTANT !
The image quality will depends on the "size" of the document. A too heavy document will
increase the transfer time (the downloading time will be higher).
The removal or the insertion of the card or the key must be done with the monitor
switched off (POWER on the remote control unit).
c. With the remote control unit
IMPORTANT ! No function of the door phone is available with the remote control unit.
1. Switch-on
The frame is switched on when it is connected to the adapter.
Insert the SD, MMC or MS card into the card port or insert the USB key.
Press the key "DEVICE" of the remote control unit to enter the source mode, and then press the
key "
" to select the desired source and press the button " ENTER " to confirm.
Advice: During an extended absence, it is advisable to remove the memory card or the USB
key, so that the unit does not enter the default automatic scrolling mode after a call.
to communicate with him.
is enough to communicate with the roadside panel.
10EN
Tabla de contenido
loading

Tabla de contenido