Extel WEVP 440 BIS Instrucciones De Uso E Instalación página 74

c. Roadside panel
The roadside panel is composed of two parts:
- a base with the rain shield
- the roadside panel with 2 short wires equipped with connectors.
Place the base, prepare the 3 mounting holes "b" and use a small housing in the part "a", where
the cables of the monitor and the automatic gate opener will pass.
This housing enables you to store the two 20 cm cables equipped with plugs (you can shorten) to
be connected to the roadside panel and the straight-joints you will use to connect the 2 wires.
Reminder:
4 wire connector to connect the monitor.
2 wire connector to connect the automatic gate opener.
From the back of the roadside panel, with a small screwdriver,
remove the 3 screw covers on the front face of the roadside panel
by carefully pushing them.
Once connected, fix the roadside panel with the 3 inserted screws
from the front face and passing through the base.
Replace the 3 screw covers so that the screws are not visible.
1,60 m
Do not expose to direct sun light or to
reflective surface.
Put a silicon gasket on the upper and
side parts, between the base and the
wall in order to avoid any vapour and
premature oxidation of electronic
parts.
Do not put silicon between the roadsi-
de panel and the protective base
9EN