Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Active Floorstander Controls
Power - This switch allows you to select either "AUTO" or "ON"
for the speakers built in amplifier. When "AUTO" is selected, the
speaker will automatically turn on when it senses a signal. It will
automatically turn off after 20 minutes if no signal is present. In the
"ON" setting the speaker will remain on as long as the AC power
cord is plugged into a wall socket. The power indicator LED on the
front panel will illuminate BLUE when speaker is on and RED when
the speaker is in standby. The LED will be off if the AC power cord
is not connected to an AC outlet.
Input Sensitivity - This switch adjusts the level of the input signal
to optimize the performance of the built-in amplifier. See "Active
Floorstanding Connections" for more information.
Bass Management
When using your speakers in a home theater system, consult
the owner's manual of your surround electronics for proper
application of bass management settings.
• As a general rule, compact speakers (Bookshelf, Center
Channel and Surrounds) are set to the "Small," or bass-
limited setting.
• Floorstanding speakers are typically set to the "Large," or
full-range setting.
• Also refer to the electronics instructions for adjusting the
relative volume levels of the speakers so they are at the same
level when in the listening position.
Care and Cleaning
• Occasional dusting or wiping of the cabinet with a cloth
is all that is required. Never use abrasive or solvent type
cleaners or harsh detergents.
• A vacuum cleaner with a soft brush attachment may be used
to clean the grille fabric.
• Never spray polishes or cleaners on the drive units (woofers,
midranges or tweeters).
FCC and Canada Compliance Information
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protec-
tion against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Approved under the verification provision of FCC Part 15 as a Class
B Digital Device.
Caution: Changes or modifications not expressly approved by the
manufacturer could void the user's authority to operate this device.
(See figure 5.)(XF-48 only)
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme á la norme
NMB-003 du Canada
EU Compliance Information
Eligible to bear the CE mark, Conforms to European Union Low Volt-
age Directive 73/23/EEC and 2006/95/EC; Conforms to European
Union EMC Directives 89/336/EEC and 2004/108/EC.
WEEE Notice
Note: This mark applies only to countries within the European Union
(EU) and Norway.
This application is labeled in accordance with
European Directive 2002/96/EC concerning waste
electrical and electronic equipment (WEEE). This label
indicates that this product should not be disposed of
with household waste. It should be deposited at an
appropriate facility to enable recovery and recycling.
4
Tabla de contenido
