Promaker PRO-TP500 Manual Del Usuario página 12

handle mounting collar (4).
3. Position the depth rod so the tip
(5) will contact the workpiece when
the drill reaches the appropriate
depth.
NOTE: The assist handle must be
placed in the horizontal position to
allow depth rod to be inserted into
the mounting collar.
Tighten the assist handle
WARNING
For safety reasons, the operator
must read
this Owner's
"GENERAL SAFETY WARNINGS",
"POWER TOOL
"SPECIFIC SAFETY
"GUIDELINES FOR EXTENSION
CORDS" and "SYMBOLS" before
using this drill.
Verify the following every time
the hammer drill is used:
1. Safety glasses, safety goggles,
or face shield is being worn.
2. Hearing protection and dust
mask are being
drilling in concrete.
the sections
Manual entitled
SAFETY",
RULES",
worn when
3. The chuck has not worked
loose on the spindle.
4. The bit is in good condition,
and is properly tightened into the
chuck.
Failure to observe these safety
rules will significantly increase
the risk of injury.
DRILLING
of
When drilling into smooth, hard
surfaces such as metal, use a
center punch to mark the desired
hole location. This will prevent the
drill bit from slipping off center as the
hole is started.
Fig.9
12