Brita Redi-Twist Manual Del Usuario página 11

auxiliary faucet installation
Install Filter and Test
for Leaks
• Insert the new Filter Cartridge over
the standpipe in the bottom of the
Filter Housing.
• Screw the Filter housing back onto
the System Head and hand-tighten.
Using the Filter Housing Wrench
(wrench sold separately), tighten 1/4
turn. Note: Do not over tighten.
• Turn on the cold water shut-off valve.
Turn on the kitchen faucet.
Allow the water to run approximately
10 minutes.
• Check for any leaks.
• If system is leaking, turn off cold
water shut-off valve and refer to
troubleshooting guide.
Auxiliary Faucet Installation Instructions
Step 4
For Drop-In Filtration System USS-120
3/8" 3/8"
auxiliary faucet installation
Filter Replacement
(every 6 months)
For FREE Filter Replacement Reminder, go to
www.protectplus.com
Note: Place bucket or rags under the filter
system to catch any water.
• Using the Filter Housing Wrench
Turn the filter right to left (as you
face it) until it releases. Remove and
discard used filter.
• Flush filter with cold water for 10
minutes.
• See Step 4 for inserting new filter.
• Changing water filter on a regular
basis ensures optimum performance
of the water filtration system.
11
Version 2.0D