Replacing Led Modules - Chauvet Professional NOVASTAR VIP Drive Nova/VD43 Guía De Solución De Problemas

Novastar Troubleshooting Guide
6. Adjust the brightness/gamma/dimming curve of the panels remotely by selecting the following:

Replacing LED Modules

• Software Required: NovaLCT-Mars
• Platform Supported: PC
The Chauvet F-series and Vivid-series video panels include MOM, or flash memory directly on the LED modules. They
are calibrated at the factory to allow the modules to be swapped within a panel or to another video panel, while still
maintaining the uniformity and superior performance.
The live-performance calibration data is stored inside the receiver cards. Therefore, if you put a new LED module in the
panel, you must recall the calibration data (coefficients) from the new LED module and save it into the receiver card. To
do this, complete the following instructions:
Instructions
The panels may be hot-swapped under power. After replacing the old LED module with the new module, you must recall
the calibration coefficients from the new LED module flash memory.
1. Open the Nova LCT-Mars software.
2. Confirm that the sender/VD43 is connected.
3. If the Control system shows "0", then select System>Reconnect to connect to the sender.
4. Log into the administrator account.
a. User>Advanced User Login.
b. Password: admin or 666.
5. Address the Video panels in the appropriate order/configuration using the Screen Configuration window before
proceeding.
Revision 1
CHAUVET VIDEO PRODUCTS
EN
9