Tabla de contenido
Warning:
Disconnecting the power cord is the only way to turn off power to this device. Always connect
the power cord in a location that can be reached quickly and safely in case of an
emergency.
Warning:
Fiber optic equipment can emit laser or infrared light that can injure your eyes. Never look
into an optical fiber or connector port. Always assume that fiber optic cables are connected
to a light source.
Installation preparation
Before you begin
Ensure the area where you install and use the switch meets environmental requirements.
You can install a single switch on any flat surface that can safely support the weight of the
switch and attached cables. A switch with two power supplies and MDA weighs 27 lbs (12.25
kg). Cable weight varies for each installation.
You can also install the switch in an equipment rack using the brackets provided or you can
use the optional four post extended bracket kit (sold separately).
Environmental requirements
The following list describes the requirements for the switch environment.
• ambient temperature between 32°F and 106°F (0°C and 50°C)
• relative humidity between 10% and 90% noncondensing
• no nearby heat sources such as hot air vents or direct sunlight
• no nearby sources of severe electromagnetic noise
• no excessive dust
• adequate power source within six feet; one circuit required for each power supply
• at least 2 inches (5.08 cm) on all sides of the switch unit for ventilation
• adequate space at the front and rear of the switch for access to cables
Avaya Virtual Services Platform 7000 Series Regulatory Information for VSP 7024XLS
Installation preparation
June 2012
17
Tabla de contenido
