SOMFY Sunea screen io Guia De Instalacion página 7

Setting the upper end limit
1) Position the awning at the upper end limit.
Press and hold the Up button for > 2 s to raise the
awning in one continuous movement.
2) Stop the awning at the desired point.
3) If necessary, adjust the position of the awning using the
Up or Down buttons.
4) Press the «my» and Down buttons simultaneously: the
awning will be lowered in one continuous movement,
even after the «my» and Down buttons have been
released.
5) At mid-height, briefly press the «my» button to stop the
awning, and go to the section «Setting the lower end
limit».
Setting the lower end limit
1) Put the awning in the lower end limit position.
Press and hold the Down button for > 2 seconds to
lower the awning in one continuous movement.
2) Stop the awning at the desired point.
3) If necessary, adjust the position of the awning using the
Up or Down buttons.
4) Press the «my» and Up buttons simultaneously: the
awning will be raised in one continuous movement, even
after the «my» and Up buttons have been released.
5) At mid-height, briefly press the «my» button to stop the
awning.
6) Press the «my» button again until the awning moves:
the end limits have been programmed. Go to the section
«Programming the first Somfy io local control point».
5.4.2. Setting for vertical awnings with upper stop only
For awnings with upper stop (load bar stopped under the head rail), the upper end limit is
automatically adjusted, while the lower end limit must be set.
Setting the lower end limit
Do not press the «my» and Down buttons simultaneously to reach the lower end limit
1) Put the awning in the lower end limit position.
Press and hold the Down button for > 2 seconds to
lower the awning in one continuous movement.
2) Stop the awning at the desired point.
3) If necessary, adjust the position of the awning using the
Up and Down buttons.
4) Press the «my» and Up buttons simultaneously: the
awning will be raised in one continuous movement, even
after the «my» and Up buttons have been released.
5) At mid-height, briefly press the «my» button to stop the
awning.
6) Press the «my» button again until the awning moves:
the end limits have been programmed, go to the section
«Programming the first Somfy io local control point».
Copyright © 2010 Somfy SAS. All rights reserved.
1 2
3 4
5
Setting the lower
end limit
1 2
3 4
5 6
1 2
3 4
5 6
Sunea screen io
5