Tabla de contenido
Idiomas disponibles
Idiomas disponibles
OPERATION
Before you begin using your thermostat, you should be familiar
with its features and with the display and the location and
operation of the thermostat buttons. Your thermostat consists of
two parts: the thermostat cover and the base. To remove the
cover, pull it straight out from the base. To replace the cover, line
up the cover with the base and press until the cover snaps onto
the base.
The Thermostat Buttons and Switches
(see fig. 8)
1 Raises temperature setting.
2 Lowers temperature setting.
3 FAN switch (ON, AUTO).
4 SYSTEM switch (COOL, OFF, HEAT).
The Display
5 Flame icon ( ) is displayed when the SYSTEM switch is in
the HEAT position. Snowflake icon ( )is displayed (non-
flashing) when the SYSTEM switch is in the COOL posi-
tion. Snowflake is displayed (flashing) if the thermostat is
in lockout mode to prevent the compressor from cycling
too quickly.
6 Displays current temperature.
7 Displays "FILTER" when the system has run for the se-
lected filter time period as a reminder to change or clean
your air filter.
8 Displays set point temperature (this is blank when SYS-
TEM switch is in the OFF position).
9 Displays "BATTERY" and "LO" in the current temperature
location when the 2 "AA" batteries are low and should be
replaced.
Step
Press Button(s)
1
Set SYSTEM
switch to OFF
2
and
3
and
4
and
5
and
6
and
7
and
Set SYSTEM
8
switch to HEAT
or COOL
* Press
and
to advance to next item
Configuration Menu
Displayed (Factory Default) Press
(FA)
d-L
(ON)
FILTER
(000)
LOC
(OFF)
0 HI
(0)
(F)
F
B
T A
E T
R
Y
9
Figure 8. Thermostat display, buttons, and switches
CONFIGURATION MENU
The configuration menu allows you to set certain thermostat
operating characteristics to your system or personal require-
ments.
Move SYSTEM switch to the OFF position, then press
at the same time to enter the configuration menu. The
display will show the first item in the configuration menu.
The configuration menu chart below summarizes the configura-
tion options. An explanation of each option follows.
Press
and
menu, move the SYSTEM switch to HEAT or COOL. If no keys
are pressed within fifteen minutes, the thermostat will exit the
configuration menu.
or
to select:
SYSTEM switch must be OFF to configure thermostat
options
SL
Select FA or SL (Fast or Slow) heating cycle rate
OFF
Select display backlight OFF or ON
0 to 1950 hours
Select Filter replacement run time
(in 50 hour increments)
ON
Select Compressor lockout OFF or ON
4 LO to
Select temperature display adjustment higher or lower
4 HI
C
Select temperature display to F or C
Returns to normal operation
4
F
L I
E T
R
8
5
7
6
to change to the next menu item. To exit the
COMMENTS
C
5
and
Tabla de contenido
