Troubleshooting - Silverline 102580 Manual Del Usuario

GB

Troubleshooting

Symptom
No detergent suction
Smoke
Pressure washer doesn't start
Poor water spray pressure
Fluctuating water pressure
Motor stops suddenly
Water leaking from pump
Maintenance
Cleaning
• Keep your machine clean at all times
• Always allow all water to drain from the pump before storing
• The Lance Nozzle (10) may get dirty or blocked over time, which will
effect operation. Clean the lance nozzle using the Cleaning Pin (16)
supplied. There is a storage slot for the cleaning pin on the rear of the
pressure washer top handle. A garden hose can also be used to clean
the nozzle by back-flushing water through the nozzle. Combining use
of the pin and back-flushing should allow the nozzle to be thoroughly
cleaned. The frequency of carrying out this task will depend on the water
quality in your area. Hard water areas require more frequent cleaning
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure,
or visible sparking
• If you suspect that the brushes may be worn, have them replaced at an
authorised service centre
8
102580_Z1MANPRO1.indd 8
Possible Cause
Blockage in detergent bottle tube
Overloaded or damaged motor
Pressurized
Mains plug not fully inserted or mains socket switch is off
RCD has operated or
not been reset
Plug fuse has blown
Thermal safety switch has operated
Water inlet filter is clogged
Water hose connection is leaking or allowing air to enter
Pressure washer valves or seals are worn or damaged
Pump is sucking in air
Clogged nozzle
Thermal safety switch has operated
Seals worn out
Solution
Clean with warm water
Do not use. Contact dealer immediately
Squeeze trigger on gun before starting
Check and correct issue
Reset RCD
Replace fuse and contact dealer if it blows again immediately
Switch off and allow pressure washer motor to cool before starting
Clean filter
Check water hose connection
Contact dealer
Check water hose connections
See Maintenance for cleaning procedure
Switch off and allow to cool before restarting
Contact dealer
Storage
Always store this machine in a dry place that will not fall below 0˚C
Disposal
Always adhere to national regulations when disposing of power tools that
are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools
23/05/2014 14:58