Dake SL913 TW Instrucciones De Uso Y De Montaje página 15

MAINTENANCE
* An accurate maintenance guarantees good fun-
ctioning and long-lasting performance.
* Particular care is due to the grease filter panel.
It can be removed by pushing its special handle
toward the back-side of the cooker hood and tur-
ning the filter downwards so to unfasten it from
its slot (Fig. 3).
To insert the filter just perform the opposite ope-
ration.
After 30 hours working (model), the push button
control panel will signal the saturation of the grea-
se filter by lighting all the buttons. Press the timer
button to reset .
The grease filter needs cleaning by regular hand-
washing or in dishwashers every two months at
least or depending on its use.
* In case the appliance is used in its filtering ver-
sion, the active coal filter (Fig. 9A-9B) needs to
be periodically replaced. The coal filter can be
removed by removing the grease filter first (Fig.
3), and by pulling its special plastic tongue until
it is unfastened from its slot. Re-insert the coal
filter by operating in the opposite way. The coal
filter needs replacing depending on the use, but
however every six months at least.
* To clean the appliance itself tepid water and
neutral detergent are recommended, while abra-
sive products should be avoided. For steel ap-
pliances specialized detergents are recommen-
ded (please follow the instructions indicated o the
product itself to obtain the desired results).
To replace the LED bar SL913
Remove the grease filter and put pressure on the
led bar placed in the internal part of the built-in
hood until you can unhook the springs, then di-
sconnect the connector and replace the bar with
a similar one (Fig. 10).
* Warning! To take down the appliance from the
cabinet, remove the definitive fixing screws (fig.
6) using a screw-driver, get off the grease filters
(fig.3B) and the active carbon filters, if they are
inserted (fig. 7A). Act on the small handle of the
springs, which are inside the built-in unit, with the
necessary strength to unhook the appliance from
the cabinet.
* If the supply cord is damaged, it must be
replaced by the manufacturer or its sevice
agent or a similarly qualified person in order
to avoid a hazard.
15