Installation Diagram - Chauvet DJ MotionOrb RXT Guía De Referencia Rápida

MotionOrb™ EXT QRG
Installing
Installation
Diagram
The MotionOrb EXT orb strings connect the MotionOrb top bar. Then the
MotionOrb standard orb strings are connected to the MotionOrb EXT orb strings.
To install the MotionOrb EXT, do the following:
1. Disconnect the standard orb strings from the top bar.
2. Attach the MotionOrb EXT orb strings directly to the top bar using the
female connector on the orb strings.
3. Attach the standard orb strings to the extension orb strings using the male
connector on the extension orb strings and female connector on the standard
orb strings.
4. Attach each of the bottom orb strings to the standard orb strings using the
male connector on the standard orb strings and female connector on the
bottom orb strings.
5. Make sure all the connections are finger tight.
6. Configure the Length setting on the MotionOrb. For more information, see
Length Setting.
7. Confirm settings by testing the MotionOrb.
The MotionOrb will not recognize the MotionOrb EXT until the Length
setting is configured.
Step 1.
Disconnect Standard
Orb Strings from
The Top Bar
Step 4.
Attach MotionOrb Bottom
Orb Strings
At The Bottom
3
EN
Step 2.
Attach MotionOrb EXT
Orb Strings Into the Top Bar
Step 3.
Attach MotionOrb Standard
Orb Strings
To The MotionOrb EXT Orb
Strings
Loops Are Always
At The Bottom