To Replace The Blades; Replace The Blades; Troubleshooting - Husqvarna AUTOMOWER 405X Manual De Usuario

WARNING:
recommended by the manufacturer. Product
safety cannot be guaranteed with other
batteries. Do not use non-rechargeable
batteries.
CAUTION:
The battery must be
charged before winter storage. If the battery
is not fully charged it can be damaged and
in certain cases be rendered useless.
The charging time can vary depending on, among other
factors, the ambient temperature.
Below indicates that the battery is getting old and
eventually needs replacing:
• The operating time for the product is shorter than
normal between charges. This leads to more
charging cycles than normal, which increases the
risk of tracks forming near the charging station.
• The product is frequently found standing out on the
Empty battery message. This indicates
lawn with
that the product does not have battery capacity
enough to find the charging station.
The battery is fine as long as the product maintains a
well-cut lawn.
Note:
Battery life is dependent on the length of the
season and how many hours a day the product is
operating. A long season or many hours of use a day
means that the battery must be replaced more regularly.
Contact your local Husqvarna representative to replace
the battery.

5.4 Replace the blades

WARNING:
the right type. Husqvarna can only

6.1 Troubleshooting

In case of malfunction, a message will appear on the display. For more detailed information on messages, refer to the
complete Operator's manual on Husqvarna's website (www.husqvarna.com). If the same message appears often or if
you still cannot find the reason for the fault, contact your local Husqvarna representative.
Breaks in the loop wire are usually the result of unintentional physical damage to the wire such as when gardening
with a shovel. Breaks can also be due to the wire being stretched excessively during installation. A wire break can be
located by gradually halving the distance of the loop where the break may have occurred, until there is only a very
short section of the wire left. Refer to the complete Operator's manual on Husqvarna's website (www.husqvarna.com).
18 - Troubleshooting
Use only original batteries
Use blades and screws of
6 Troubleshooting
guarantee safety when using original blades.
Only replacing the blades and reusing the
screw can result in a screw wearing during
mowing. The blades can then be propelled
from under the body and cause serious
injury.
Replace worn or damaged parts for safety reasons.
Even if the blades are intact, they should be replaced on
a regular basis for the best mowing result and low
energy usage. All 3 blades and screws must be replaced
at the same time to obtain a balanced cutting system.
Use Husqvarna original blades embossed with the
crowned H-mark logotype, refer to
page 23 .

5.5 To replace the blades

1. Switch off the product with the ON/OFF button.
2. Put the product upside down on a clean and soft
surface.
3. Rotate the skid plate until the holes align with the
screws for the blade.
4. Remove the 3 screws.
5. Remove the 3 blades and the screw.
6. Attach 3 new blades and screws. Use Husqvarna
original blades.
7. Make sure that the blades can move freely.
Warranty terms on
1508 - 004 - 22.12.2020