Proscenic M8 PRO Manual De Instrucciones página 26

Dust collector unit
This product will prompt you the current product status through the indicator light on the top of the body:
Indicator light
Fan error / overheating / dust col-
lection port is blocked / the cover
Flashing red is not closed properly
The dust bag is full / not installed
/ not installed in place / the dust
Flashing red collector cover is open
Failed to pair / Haven't paired yet
flash
simultaneously
Common error Solution
1. Frequent dust collection leads to fan overheating protection or fan malfunction. It
is recommended to try to collect dust after 30 minutes;
2. Clean up the debris in the dust collection port at the bottom of the robot and in
the dust collector;
3. Unplug the dust collector, turn the dust collector over, check whether there is any
foreign matter in the dust duct cover on the bottom, use a screwdriver to remove
the screw and open the dust duct cover to clean the foreign matter.
1. Replace with a new dust bag;
2. Check whether the dust bag is installed, if not, please install the dust bag.
3. Check if the dust bag is installed correctly and in place.
4.Make sure that the dust collector cover is completely closed, sealed securely, and
the robot has been placed on the dust collector to charge, and try to collect dust
once. The method of manually collecting dust is as follows:
Short press the on/off button on the robot, after the robot leaving the dust col-
lector, press any button on the robot to pause, and then press and hold
seconds, the robot will return to the dust collector to start collecting dust, and the
robot will return to charge automatically after the dust collection is completed.
1. Press and hold the both buttons
for 5 seconds: The dust collector goes into pairing mode, the three indicators of
the dust collector flash green;
2. Press and hold the button
pairing mode, the indicators of the robot flash green;
3. Place the robot at the dust collector to charge, and the voice prompts that the
pairing is successful.
and
for 5 seconds on the robot: The robot goes into
22
simultaneously on the dust collector
for 3