Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Bulb Installation and Replacement
CAUTION: When replacing bulbs, turn power
off and let the fixture cool.
Important: Use a clean glove or cloth when handling
the new bulb. Use isopropyl (rubbing) alcohol to clean
the bulb if it is touched with your bare hands.
NOTE: Bulbs are included, but need to be installed.
The bulbs are located behind the glass cover of
each lamp head.
1. Open lamp head with a phillips head screwdriver.
To remove the old bulb, push the bulb towards the
right until the left side of the bulb is clear of the left
socket.
2. To install the bulb, place one end of the bulb on the
contact in the right socket. While pushing the bulb
against the right contact, lower the other end of the
bulb onto the contact in the left socket.
3. Spin the bulb to verify it is seated properly.
4. Close the lamp head and tighten locking screw
securely.
Bulb
Left
Socket
Contact
2
598-1159-07
Lamp Head
1
Right
Socket
Glass
Cover
Wire the Light Control
WARNING: Turn power off at circuit breaker
or fuse.
1. Remove the existing light fixture.
2. Strip about 5/8" insulation from the existing junction
box wiring.
3. Route the light control's wires through the large
hole in the gasket.
4. Twist the junction box wires and fixture wires together
as shown. Secure with wire connectors.
White to White
Mounting
Strap
Connect any fixture ground wire(s) and the cover
plate ground screw to the junction box ground
wire.
Mount the Light Control
1. Align the light control cover plate and cover plate
gasket and the junction box. Insert and tighten the
mounting screws.
2. If not installed on a weatherproof box or if an adaptor
plate is used, caulk the wall plate and mounting
surface with silicone weather sealant.
RIGHT
The halogen light must be
mounted horizontally (+/- 4°).
3
Black to Black
Rubber
Mounting
Gasket
WRONG
Plug
Bolt
Tabla de contenido
