miniland baby 89093 Manual De Instrucciones página 15

access the settings menu. Select the settings submenu on the monitor by pressing the
icon and select the Movement detection option.
To enable and disable this function, press the first of the icons that appears on the screen.
You should also choose the sensitivity level of the camera before movement detection from
amongst the 3 levels available.
It also has an additional function available which allows it to record images for a
programmable time period when the camera is activated because a movement has been
detected.
If you wish to see your baby at a certain time, even if there is no noise about, touch
the screen and the image will be reactivated.
5.2.7. VOLUME/TRANSMITTING POWER
This menu will allow you to configure the volume level at which the parents' voices will be
reproduced on the camera by using the two-way function.
Press the menu button on your monitor to access the main menu and on the icon to
access the settings menu. Select the settings submenu on the monitor by pressing the
icon and select the Volume/Transmitting Power option.
You can choose between its 10 levels (0-9), pressing the signs + ó -, whichever you
require.
What's more, on this menu you can change the power level transmitted by the camera,
choosing from amongst the high/low options. When at the HI position (HIGH), coverage will
extend 300 metres in open country with the original power. When at the low position (LOW),
the maximum transmission distance is reduced to around 150 metres in open country and
the transmitting power is reduced.
You can also control this function from the mains screen. Press the icon and this will
appear accompanied by the power level transmitted (LO, HI). Any modifications made
directly on the main screen will solely affect the camera which is capturing the images
shown.
5.2.8. PAIRING
This product is designed to allow the observation of different areas with up to 4 cameras
(channels 1, 2, 3 or 4 assigned to different cameras). The monitor and the original camera
leave the factory with channel 1 programmed. If you need to add an extra camera, follow
the process set out below.
Press the menu button on your monitor to access the main menu and on the icon to
access the settings menu. Select the settings submenu on the monitor by pressing the
icon and select the Pairing option.
After entering the Pairing submenu, select the channel on which you wish to link the new
camera by pressing the corresponding icon. The icon will then change and the on/link
(2) LED indicator of the monitor will flash green. Press the camera link button (V) and, if the
process has been successful, the icon will appear instead of the previous one and the
LED indicators will go green. If the connection has not been made correctly, the icon
will appear. Should this be the case, try again with the same channel or another one where
necessary.
For various reasons you may lose the connection between the monitor and a camera which
is already connected. Should this be the case, repeat the process explained above to
connect the camera with the monitor again.