ATTACHING THE FAN BLADES
Step 2. Fasten blade assembly to the holes located on the bottom of the flywheel.
Tighten the two "pre- installed" motor screws in the blade bracket. Repeat steps for
the remaining blades assemblies.(Fig. 14)
INSTALLING THE SWITCH HOUSING
NOTE: Before continuing , make sure the power is disconnected by turning o the
circuit breaker of removing the fuse at the circuit box.
Step 1. Remove one of the screw preinstalled on mounting plate and keep for later
use. Loosen the other two (do not remove). Place the two slot holes on the switch
housing over the 2 screws previously loosened from the mounting plate. Rotate the
switch housing until it locks in place at the narrow end of the key holes. Securely by
tightening the 2 screws previously loosened and the one previously removed. (Fig. 15)
12
Mounting Plate
Blade Assembly
Fig. 14
Screw
Mounting Plate
Switch Housing
Fig. 15