Memory Operation - Kingfisher KI23400 Serie Guía De Referencia Rápida

•
Connect an instrument at each end of a fiber link.
•
Start 2-way Autotest on any of the connected instruments.
•
For near-end unit to 'flag' far-end unit: Press F4 on near-end
unit. Far-end instrument will beep once and, "HOLD" will
flash (display update stops) on both units.
•
For far-end unit to respond to near-end unit: Press F4 on far-
end unit. Near-end instrument will beep once and, "HOLD"
will stop flashing (display update resumes) on both units.
Autotest Wavelength Restriction:
•
To start Autotest with restricted wavelengths,
Method 1(for instrument with 2 light source ports only),
To start Autotest for single mode λ (left source port),
▪
hold down - and press F4.
To start Autotest for multimode mode λ (right source
▪
port), hold down + and press F4.
Method 2,
▪ To activate
wavelength/s for Autotest, press F1 in Home menu,
then press – or + to select the wavelength/s. Hold F4
then press Toggle Centre to change between 'in'
(activated) or 'out' (deactivated).
▪ To start Autotest for the activated wavelength/s only,
hold Toggle Centre then press F4.

Memory Operation:

Recording Data to Memory
(include) / deactivate (exclude)
•
In METER or AUTO mode, press triangular button above "STORE".
•
To change the next location pointer for storage, press button
above "MEMORY" at Home menu, select desired location
using the + or -, hold button above "MEMORY" then press
F2 for three seconds, or until it stops beeping.
Recalling Stored Data from Memory
•
To enter Memory mode, press button above "MEMORY" at
Home menu.
•
To select a memory location to display data, press + or -.
•
[For data saved in 2-way Autotest mode only]: To toggle
display to show summary or detail data of test results, press
F3 repeatedly.
To show nominal source power, hold down left rectangular
button above LCD (only when display shows detail data).
To view detail data for other wavelengths, press F4.
To view saved time and date, press and hold Toggle
Centre.
To exit memory mode, press F1.
•
[For data saved in 1-way Autotest mode only]: To toggle
display to show absolute power in dBm or in both dBm and
watt, press F3 repeatedly.
To show nominal source power, hold down left rectangular
button above LCD.
To view saved time and date, press and hold Toggle
Centre.
To exit memory mode, press button below [HOME].