Skil LT4818-00 Manual Del Propietário página 19

Reload the Cutting Line
NOTICE: When the cutting line breaks from the line outlet or the cutting line is not released
when the trimmer head is tapped, you will need to remove the remaining cutting line from the
spool retainer and follow the steps below to reload the line.
1. Remove the battery pack from the trimmer.
2. Press the release tabs on the upper cover and remove the lower cover of the trimmer
head by pulling it straight out (Fig. 17 & 18).
Fig. 17
3. Remove the cutting line from the spool retainer.
4. With one hand holding the upper cover, use the other hand to grasp the lower cover of the
trimmer head and align the tabs on the upper cover with the holes in the lower cover; use
your palm to press the lower cover until it snaps into place. (Fig. 19 & 20).
5. Following the instructions in "Line Replacement" to reload the cutting line.
Fig. 19
Fig. 18
Release
Tab
Fig. 20
Alignment
Upper Cover
Lower Cover
19