ergoCentric upCentric Manual Dei Usuario página 6

Step 10B: Run cords from all three legs to the Control Box. For the
Extended Leg, run the cord between the tabletop and the frame through
the small Inlet Hole and the clip cords into the Wire Clips
to stop the wire from hanging out. Do not connect cords to
CIRCLES )
control box.
Note: For ideal
positioning, the table
top should extend past
the frame by 2"-6" when
possible.
Add Plugs into
Step 11:
( PART O )
holes on each side of the frame.
10
Step 12A:
cord out to the desired location. Run the wire between the frame and
the tabletop through small inlet hole and screw down to the underside
( SHOWN WITH
of the tabletop.
Step 12B:
Power Cord
into the back of the
Control Box
and run it between
the frame and the
tabletop through the
small inlet hole.
Step 13:
and attach by inserting Screws
the designated holes.
Step 14:
control box.
Step 15:
leg using Bolts
Plug Handset into the Control Box
( PART L )
Plug
( PART K )
12A
( PART J )
Center the frame on the tabletop
in
( PART B )
Attach/Connect all (5) cords/plugs to the
Attach feet to the ends of each
( PART N )
.
( PART A )
and run
( PART J )
11