Important Information; Safety Instructions; During Operation - ergoCentric upCentric Manual Dei Usuario

Important Information

• Always make sure all screws are tightened before
use of the table and after moving or transporting.
• Duty cycle of the frame for desk is 10 %, max.
2 minutes operating/min. 18 minutes stop.
• Maximum load of the table is 420 lbs. (190kg).
Ensure the loading on each leg is less than 150 lbs (68kg)
otherwise it might cause permanent damage to the
leg(s) during operation.
• When the motor cable is connected to the control box
the legs can maintain an adequate locking force up to
420 lbs. (190kg) load on the table top. However, when
the cable is damaged or is disconnected from the control
box, it will cause the desk to sink to the bottom within hours
if the load on either leg is larger than 150 lbs (68kg).
• Make sure that no persons or items will collide with the
table, when adjusting upwards and downwards.
• Damaged cords must be replaced before connecting
the main power cable.
• Keep at least ¾" of free space around the whole
frame/tabletop.
• The upCentric is not intended to be used as a person lift.
• Do not pull or push the table if adjusting.
• Do not lift the frame above the table off of ground
when adjusting.

Safety Instructions

Before Installation/Reinstallation
Make sure that the table is being installed as described in the "Connection"
section, page 12 in this Owner's Manual. When installing and using electrical
equipment, basic safety precautions should always be followed to avoid a risk
of fire, electric shock, or injury to persons :
4
1. If the power cord is damaged it must be replaced.
2. Do not open any electrical components
(control box, motor housing, handset).
3. Never drop or insert any object into any opening.
4. Make sure the correct tools and assembly parts are
used when assembling the system.
5. Before transporting the table, always remove the
power cord from main power supply.

During Operation

1. Not intended for use by children.
2. For indoor use only.
3. Do not use table when the load exceeds 420 lbs. (190kg)
4. Always unplug the table from the electrical outlet before cleaning.
5. Unplug from outlet before installing or removing parts.
6. Keep the cord away from heated surfaces.
7. Do not operate where aerosol (spray) products are
being used or where oxygen is being administered.
8. To disconnect, lower table to minimum height,
then remove plug from outlet.
9. If table is heavily loaded, keep load away from edges
to prevent the possibility of the table tipping over.
10. Any servicing is to be performed by an authorized service
representative. Contact service@ergocentric or 1 866 438 3746
for more information.
11. Make sure that no persons or items will collide with the table when
adjusting upwards and downwards.
12. If the control box or the legs make any unusual noises or smells,
immediately unplug table from power supply.
5